• Keystone Insignia 01
  • Keystone Insignia 02
  • Keystone Insignia 03
  • Keystone Insignia 04
  • Keystone Insignia 05
  • Keystone Insignia 01
  • Keystone Insignia 02
  • Keystone Insignia 03
  • Keystone Insignia 04
  • Keystone Insignia 05

Keystone
Insignia® Wall

Insignia

Successfully blends rustic and modern aesthetics.

More the just a pretty face, Insignia Wall brings strength and beauty to every hardscapes project.

Insignia Wall combines rugged texture with smooth lines and color to create a look that is both classic and contemporary.

Insignia® Product Information

    • Limestone Creme

    Additional colors and blends available upon request. The colors seen here may not be an exact representation of the actual color. See your representative for color samples. When using color blends, we recommend working off multiple pallets to get the best color results.

  • Headwaters Concrete Products is strategically located to serve the North Texas, Houston and San Antonio metropolitan areas, East Texas and Louisiana. We also service areas outside of Texas and Louisiana. All locations are open to the public.

    Find a Location

    • Prepare the Site • Begin by digging a shallow trench 6” Deep by 15” wide. Add 2” of crushed stone and compact to create a level base. Use sand (do not exceed 1") as needed to aid in leveling.
    • Set the Base • Start at the lowest point of the wall and place the first unit of Insignia Wall (Chamfer up as shown), leveling it front to back and side to side both independently and with the adjacent units.
    • Pin • Each Insignia Wall unit requires two Keystone Pins. Pins should fit easily into pin holes and align parallel with the front and back of the unit.
    • Backfill • Backfill behind the completed course and after the installation of each additional course with crushed stone aggregate. Optional: Fill the unit channels with crushed stone aggregate.
    • Adding Courses • Stagger the bond from the previous course as shown. Pins from the lower course will secure into the front pin receiving channel in the bottom of the unit being installed. Push the wall unit back until the pins contact the outside edge of the channel.
    • Capping • Finish the wall with Insignia Cap for a polished look. Depending on the design of the wall, cutting of the cap units may be necessary. Secure the cap units with concrete adhesive.
  • Pins • Two pins are required for each unit. Sold in bags of 50.

Insignia Estimating Chart

Use this chart to estimate the number of units you will need. Wall Length is measured at wall face including curves.

Wall Height 5' Length 10' Length 15' Length 20' Length 25' Length 30' Length
4" (1 course) 5 10 15 20 25 30
8" (2 course) 10 20 30 40 50 60
12" (3 course) 15 30 45 60 75 90
16" (4 course) 20 40 60 80 100 120
20" (5 course) 25 50 75 100 125 150
24" (6 course) 30 60 90 120 150 180
2.5" Cap course 5 10 15 20 25 30

Features and Benefits

  • The Insignia Wall unit is open-cored, making it lightweight and easy to handle.
  • Insignia Wall units use the latest in modular pin connection technology; making them easy to install and adding strength to your project.
  • The Keystone Insignia Cap is double-sided, which allows you to create a seamless and attractive finish to your Insignia Wall or project.
  • The Insignia Cap also has the versatility to be used as a non-critical retaining wall structure, no alignment pins required.
  • Perfect for: Planters, Tiered Walls, Small/Medium Walls